To cancel a “MANUAL WATER All Stations” entry, simply turn the
Lower Line knob to “0.0 Minutes.” The manual valve currently on
will stop irrigation, and no other manual valves will irrigate.
Note: Manual watering will occur immediately regardless of what
other stations are on and will run concurrently with all other
programmed stations.
The RUN display below shows manual irrigation at Station 3.
Understanding Alerts
The ALERTS feature provides status alerts for key functions of
WeatherTRAK ET plus.
ALERTS covers issues related to Water Window Status, Day Status,
Communication Status and Electrical Status.
If any one or more status sections are in ALERT mode, then the third
line of the display (on all screens, not just in ALERTS) will read:
“Status: Warning See Alert.”
This will display until you fix the problem associated with each alert.
To fix Day Status alerts: reset the available water days or day
interval in the month displayed in the alert. You can also increase the
root depth for the alert station.
To fix Electrical Status alerts: repair the electrical system or
component that has caused the short. The alert will then go away on
the next irrigation run.
To fix Water Window Status alerts: expand the water window, reduce
the run times with the ADJUST feature, or allow more days to irrigate.
To fix Communication Status alerts: call HydroPoint Customer
Service at: (800) 362-8774.
To see alerts:
Turn the Function Selector knob to ALERTS.
To Next Page
Loading...