2. The choices using the Lower Line knob are:
• Specific Stations (Default Setting) and
• All Stations.
3. Turn the Upper Line knob.
The display will look like this:
The lower line of the display shows the default setting. Only
whole minutes are set.
4. Turn the Lower Line knob to the desired minutes for manual
operation. These include:
• 00 to 99 (Default Setting: 00.0).
Manual irrigation starts immediately on Station 1. The display
will change to show the status of irrigation as in the example
below (time set for two minutes).
There are 1.9 minutes remaining on Station 1. After Station 1 has
completed watering, Station 2 will go on for two minutes, then
Station 3, etc. to the last station on the controller. When all
irrigation is finished, the screen will change to this:
Note: If the Function Selector knob is turned to the OFF
position, after one (1) second, the MANUAL mode stops. (This
prevents momentary interruption of any irrigation when rotating
the Function Selector knob through the OFF position.)
To Next Page
Loading...