2. Turn the Lower Line knob to select a lock phase. Your choices are:
• A,
• B,
•C or
• None (Default Setting).
When you lock onto a phase other than “None,” the controller will
beep when receiving your activation message.
Important:
This feature is used only at ET Everywhere service activation. After
activation all phases are ‘live’ and will be used to receive daily ET
updates. Locking on a phase at activation allows for a faster
activation process. At midnight of the day of activation, the
controller will “unlock.”
Displaying the Microzone
The microzone provides the specific location of the controller and
enables WeatherTRAK ET plus to receive its daily local ET updates.
To view the microzone, turn the Upper Line knob until you see:
This displays the current microzone. The value shown is the default
value.
Note: The microzone is transmitted to each controller during ET
Everywhere service activation. You do not set the microzone.
To Next Page
Loading...