Displaying the Group Number
The group number may be assigned at activation or at a later date via
HydroPoint Customer Service. If not assigned, the default is 00000.
This number is used to group controllers together for sending ET
Everywhere service messages.
To view the group number:
1. Under SETUP, turn the Upper Line knob until you see:
2. You can now return the Function Selector to RUN or another
programming function. If you return the Function Selector to
RUN, the display will show the current time and date.
Setting the Maximum Backup ET
This value is used by the controller as a backup in the event that a
communication failure occurs with WeatherTRAK ET plus and daily
ET values are not received.
To set the maximum backup ET:
1. Under SETUP, turn the Upper Line knob until you see:
The lower line shows the default setting: “2.00.”
2. Turn the Lower Line knob to select a number from “0” to “9.”
3. Continue to turn the Upper Line and Lower Line knobs until
you have selected the correct three-digit number.
Note: The maximum backup ET value includes a seasonal curve
associated with the set number such that it that will
automatically adjust the backup ET value according to the time
of the year. You should set this to the value you want for the
highest ET time of the year.
To Next Page
Loading...