After you select a schedule, please see the following procedures for
the schedule that applies to you.
If you selected “Automated by WeatherTRAK,” you will see the
following display:
This is the default setting. You can set a non-watering day if you
wish. The controller will never allow any watering on the day you
select. If you want to allow the controller to water on any day, select
“None.”
To select a non-watering day, turn the Lower Line knob to choose one
of the following:
• Sun through Sat or
• None (Default Setting).
Note: This is a “hard” non-water day and WeatherTRAK ET plus will
never water on the day you selected. WeatherTRAK ET plus may also
skip days if it determines that irrigation can wait until the next water
day. If the soil reservoir has enough water for the plant material, it
may skip a day.
If you selected “Odd/Even,” you will see the following display:
Turn the Lower Line knob to choose one of the following:
• Odd (Default Setting) or
• Even.
WeatherTRAK ET plus will NOT water on the current day if it does
not meet the schedule.
Note: If you select “Odd” watering day, the controller will allow
watering on both day 31 of the current month and day 1 of the
following month.
To Next Page
Loading...