Manual Water Specific Stations
1. Turn the Function Selector knob to MANUAL.
The display will look like this:
2. Leave the setting at the default of “Specific Stations.” The
choices are:
• Specific Stations (Default Setting) or
• All Stations.
The process to manually water specific stations is to first set the
station with the Upper Line knob, and then set the amount of
time with Lower Line knob.
3. Turn the Upper Line knob to the next position.
You can set each station for a different time. In this example, we
will set Station 4 to water for 10 minutes.
4. Turn the Upper Line knob to “STA 04.” The other settings
include:
• STA 01 through 12 (Default Setting: STA 01)
Minutes
The lower line shows the default setting. Only whole minutes are set.
5. Turn the Lower Line knob to “10.0.” The other settings include:
• 00 to 99 (Default Setting: 00.0).
To Next Page
Loading...