Hypertherm Powermax30 XP Service Manual

Powermax30 XP Service Manual 808150 Revision 0 119
6 – Power Supply Component Replacement
Replacing the drain hose, gas supply hoses, and 90° fitting
The Powermax30 XP contains a drain hose and two gas supply hoses that can be replaced. (See Figure 57.)
 The drain hose runs from the bottom of the air filter bowl to the base of the power supply.
 One gas supply hose runs from the air filter/regulator to the solenoid valve.
 The other gas supply hose runs from the solenoid valve to the torch lead.
You can also replace the plastic 90° fitting that connects the gas supply hose from the solenoid valve to the gas supply
fitting from the torch lead.
The gas supply hoses in this system use push-to-connect fittings.
Figure 56 – How to use push-to-connect fittings
Kit number Description
228095 Kit: Hoses: drain hose, two gas supply hoses, elbow fitting
Push-to-Connect
 To connect, push the hose into the fitting until it stops. Pull on the hose to verify that it is secure.
 To release, push the fitting collet toward the fitting, and pull the hose away from the fitting.
1
2
3
Hose Collet O-ring
1
2
3

Hypertherm Powermax30 XP Specifications

General

Brand	Hypertherm
Model	Powermax30 XP
Category	Welding System
Language	English