Hypertherm Powermax30 XP Service Manual

Powermax30 XP Service Manual 808150 Revision 0 23
Section 2
Power Supply Setup
Unpack the Powermax system
1. Verify that you received all items on your order in good condition. Contact your distributor if any parts are damaged or
missing. (See System contents on page 24.)
2. Inspect the system for damage that may have occurred during shipment. If you find evidence of damage, refer to
Claims. All communications regarding this equipment must include the model number and the serial number located
on the bottom of the power supply.
3. Before you set up and operate this Hypertherm system, read the separate Safety and Compliance Manual (80669C)
included with your system for important safety information.
Claims
 Claims for damage during shipment – If your unit was damaged during shipment, file a claim with the carrier. You
can contact Hypertherm for a copy of the bill of lading. If you need additional assistance, call the nearest Hypertherm
office listed in the front of this manual.
 Claims for defective or missing merchandise – If any component is missing or defective, contact your
Hypertherm distributor. If you need additional assistance, call the nearest Hypertherm office listed in the front of this
manual.

Hypertherm Powermax30 XP Specifications

General

Brand	Hypertherm
Model	Powermax30 XP
Category	Welding System
Language	English