Hypertherm Powermax30 XP Service Manual

42 Powermax30 XP Service Manual 808150 Revision 0
4 – Operation
Install the consumables
To operate the Duramax LT torch, first verify:
1. The power switch is in the OFF (O) position.
2. A complete set of consumables is installed as shown in Figure 5.
3. You use only the shield (420116) with the general-purpose nozzle (420118).

To understand the differences between the general-purpose and FineCut consumables,
and for guidelines on selecting the right set for your cutting applications, see Choose the
consumables on page 32.
WARNING!
INSTANT-ON TORCHES
PLASMA ARC CAN CAUSE INJURY AND BURNS
The plasma arc ignites immediately when you press the torch trigger. Make
sure the power is OFF before changing consumables.
I
O

Hypertherm Powermax30 XP Specifications

General

Brand	Hypertherm
Model	Powermax30 XP
Category	Welding System
Language	English