Hypertherm Powermax30 XP - Page 164

164 Powermax30 XP Service Manual 808150 Revision 0
6 – Power Supply Component Replacement
4. Disconnect the air filter/regulator’s drain hose from the hole in the base of the power supply.
5. Use a 8 mm (5/16 inch) nut driver to remove the nut that attaches the ring connector for the output inductor’s white
wire to the stud labeled “WHT.”
Figure 95
2
3
1
1
Drain hose
2
Output inductor
3
White wire stud (“WHT”)