Hyundai Elevator WBVF

To Next Page

To Previous Page

WBVF

．

INSTALLATION MANUAL

FOR ELECTRICAL PARTS

Doc. No

Ver.

11.0

Date

2019-04-02

Page

7 / 98

4.1 CTC Board ..................................................................................................................................................................................93

4.2 CTX Board ..................................................................................................................................................................................93

Main Page

Table of Contents3
Safety Information8
Introduction of WBVF System9
WBVF Motor Control Block Diagram9
WBVF Standard Controller Layout10
Preparations for Installation13
Machine Room Environment13
Location of the Control Panel13
Precautions for Installation15
Check List before Installation18
Low Speed Test Drive20
Introductions of Machine Room Connection20
Process of Low Speed Test Drive21
Line Connection21
Low Speed Test Drive22
Check List for Low Speed Test Drive23
Hoist Way Cable Harness24
How to Connect Traveling Cable (T-Cable)24
Components of Hoist Way Cable Harness25
Connect HPI to Hall Call Button in the Call Button Box25
How to Connect Hoist Way Cable Harness26
Inside/Outside CAR31
How to Install CAR Junction Box31
How to Install Landing Device (Landing Control Device)34
How to Install OPB37
OPB Connection Information37
Load Switch38
Cautions During the Connections between CAN Communication Boards40
How to Set Hall Indicator Device43
Other Matters for Setting43
Voice Synthesis Device Speaker Volume Adjustment43
Cautions During the Replacement of COP-30D Board43
Machine Room Harness44
MCPU Connection44
Board Composition44
Connector Name45
Option Board45
Main Board Power Specification46
Check Points after Supplying the Power46
SAF Board Connection47
SAF Board Composition47
Connector Names48
USAF Board Connection49
USAF Board Composition49
Connector Names50
UCMP Board Connection51
UCMP Board Composition51
Connector Names52
High Speed Test Drive53
Check List before High Speed Drive53
Balance Work53
Door Operator Work53
Landing Control Operation Verification53
Final Limit Switch Operation Verification53
How to Set the Initial Operation54
How to Set the Initial Operation for EN81-20 Project55
How to Test High Speed Drive57
Simple Mode57
How to Register Manual Call Using HHT60
How to Set Display Code for each Floor Using HHT61
How to Set Load for Load Cell62
How to Set Hall Indicator64
Indicator Installation and Floor Input64
Hall Indicator Operation and Troubleshooting67
Verification of Other Optional Functions67
Finish Work67
How to Operate Pit Inspection68
Enter into the Pit68
Getting out from the Pit68
How to Operate Door Bypass Function68
Appendix A. VCON Board Manual69
Appendix B. Inverter Initial Start-Up Manual72
Appendix C. Description WBVF System Board75
Main Power76
Dot Matrix81

Hyundai Elevator WBVF - Page 7

Table of Contents

Related product manuals