Quick Start Guide ~ RCON PROFINET IO Specification ~
p105
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Operation
Table
of
Contents
“Confirmation” window
Click [Trsf] on the top of the position data edit window.
(4)
As a “Confirmation” window appears, click [Yes] .
(5)
“Position data edit” window
Input any coordinate value in the range displayed in the input range and press
the [Enter] key on your PC.
(In the example below, inputs 0mm in Position No. 0 and 100mm in Position No. 1.)
(3)
“Position Data Input Part” Window
Input the position and press the “Enter” key, and the actuator
rated values already registered in the controller should get
automatically input for the other cells such as velocity,
acceleration and deceleration.
When it is necessary to make a change, move the cursor to each
point and input a value. The range for input should be displayed
at the bottom of the screen.
Input the
position
+
[Enter]
(4)
Click
(5)
Click
To Next Page
Loading...
