IAI RCON Series - Page 117

Quick Start Guide ~ RCON PROFINET IO Specification ~
p117
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Operation
Table
of
Contents
Reference
Pressing Operation Setting / Adjustment
●Pressing force displayed in “N” units are reference.
Refer to the instruction manual or catalog for each ELECYLINDER for detail.
●When the pressing velocity is low, the pressing force may get unstable and
the operation may get inappropriate. The pressing velocity may vary
depending on models. Refer to the instruction manual or catalog for each
ELECYLINDER for detail.
Click in the checkbox on “Pressing” to switch to the pressing operation window.
(1)
“Simple data setting” window
Input a value in “Pressing Force” and “Pressing Start Point”.
(2)
“Simple data setting” window
Transfer data.
(3)
In order to perform the pressing operation, establish the settings in the following
process.
(1)
Click
(2)
Input
+
“Enter”
(2)
Input
+
“Enter”