IAI RCON Series - Page 13

Quick Start Guide ~ RCON PROFINET IO Specification ~
p13
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Wiring
Table
of
Contents
For the wiring on the SCON main body, refer to Quick Start Guide SCON
(ME0369).
★A terminal connector
(terminal resistor) is
necessary on the final axis.
2
Connecting SCON and Extension Unit
Assemble in the following procedures when the specification of the RCON system
includes an SCON extension unit.
RCON system
Extension Unit
Connection Cable
CB-RE-CTL***
(1)
Insert a cable connector to the connector on the SCON extension unit.
(2)
Plug in the other end of the cable connected to the SCON extension unit
(or PIO/SIO/SCON extension unit) to “IN” side of the RCON connector
in the SCON_RC specification.
(3)
Put in the terminal connector (terminal resistor) to the RCON connector
on the “OUT” side of SCON.
Connection Cable
CB-RE-CTL***
RCON
Connector
“OUT”
“IN”
SCON_RC
specification
Connection Cable
CB-RE-CTL***
RCON
Connector
“OUT”
“IN”
Terminal Connector
(Terminal resistor)
RCON-EXT-TR
SCON Extension Unit (Model: RCON-EXT)
RCON system