IAI RCON Series - Page 45

Quick Start Guide ~ RCON PROFINET IO Specification ~
p45
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Initial Setting
Table
of
Contents
Click [OK] in the “Communication establishment” window.
(5)
(5)
Click
”Communication establishment” Window
“Establish Communication”
window should show controllers
or drivers connected to COM No.
Selected in (4).
Controllers
subject to the
communication
are available to
select.
(6)
Click
”Warning” window
Click [Yes] in the “Warning” window.
(6)
Example:
For “Actuator Control Method”, select:
→ “Teaching Mode
(operate with this application)”
And for “Safety Velocity”, select:
→ “Enable
(maximum speed is limited)”
(7)
Click
(7)
Select
(7)
Select
”MANU Operation Mode setting” window
Select “MANU Operation Mode setting” and click .
(7)