IAI RCON Series - Page 49

Quick Start Guide ~ RCON PROFINET IO Specification ~
p49
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Initial Setting
Table
of
Contents
”User Parameter Setting“ window
Make sure that transfer of the parameters will be made. Without the transfer
of parameters, the setting would not be reflected.
Click [Tr] in the “User Parameter setting” window.
(7)
(7)
Select
”Check Process for Parameter Transfer“ window
(8)
Click
Click [OK] in the “Check Process for Parameter Transfer”.
(8)
”Information“ Window
“Information” window should open after the transfer is complete.
Click [OK] .
(9)
(9)
Click
”Information“ Window
(10)
Click
“Information” window should open after the software reset is complete.
Click [OK] .
(10)