IAI RCON Series - Page 48

Quick Start Guide ~ RCON PROFINET IO Specification ~
p48
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Initial Setting
Table
of
Contents
The number of axes of the connected drivers should be automatically input in
the “Number of axes setting” in the “user parameter setup” window.
(5)
”User parameter setting“ window
The axis number setting of drivers should be automatically assigned as well as
the number of axes setting.
The number of axes setting can be changed as necessity.
The number of option unit connection should be automatically input.
(6)
(5)
Automatic
input
”User parameter edit“ window
RCON system
SCON-CB-RC × 1 unit
RCON-PC-2 × 1 unit
RCON-SC-1 × 1 unit
RCON-EC-4 × 1 unit
* In the example, drivers for
four axes are connected.
* In the example, one unit
of option unit is connected.
Option Unit:
It is the EC connection unit connected
in the RCON system.
(6)
Automatic
input