IAI RCON Series - Page 47

Quick Start Guide ~ RCON PROFINET IO Specification ~
p47
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Initial Setting
Table
of
Contents
”Information” window
Once “Information” window at initial connection is open. Click [OK] .
(3)
(3)
Click
The setting window for the user parameter should be displayed in the
“IA-OS Main” window.
(4)
“IA-OS Main” window
”Alarm information“ window
Alarm “08BA: Number of axes/operation mode mismatch” in the gateway
would occur when the number of axes set in the gateway parameter and the
number of axes figured out from the operation mode set in the gateway are
not matched. This error should be solved by establishing the gateway
parameter setting.
Click [Close] in the “Alarm information” window.
(2)
(2)
Click
The parameter setting
window should be
displayed.