IAI RCON Series - Page 79

Quick Start Guide ~ RCON PROFINET IO Specification ~
p79
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Initial Setting
Table
of
Contents
Click the “Select Device” area and select .
“TIA Portal main” window
“TIA Portal main” window
RCON system
Occupancy Information
IN 4 word module : 7
OUT 4 word module : 7
Input 4 word × 7
Output 4 word × 7
“Device Overview (I/O Module Assignment)” of the iai-prt should be displayed.
Confirm that the 4-word module is set for the necessary quantity.
* For the online connection, the I/O module should automatically be assigned
following the content of the set controller.
In order to change the I/O module addresses (I Address / Q Address) in PLC,
double-click the address and input a value.
A communication error should occur when the address is duplicated at this
moment. Pay attention not to make duplication.
Double-
click
&
Inpu
t
“Device Overview (I/O Module Assignment)”
(4)
Select
(4)
Click
(5)
(4)