IAI RCON Series - Page 97

Quick Start Guide ~ RCON PROFINET IO Specification ~
p97
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Operation
Table
of
Contents
“Communication method selection” window
Click [Serial Com] in the “Communication method selection” window.
(3)
The “Select communication port” window will be displayed.
Select a COM number of the controller to be connected in the “communication
port list” and click [start com] .
(4)
”Select communication port” window
(4)
Click
(4)
Select
Click [OK] in the “Communication establishment” window.
(5)
(5)
Click
”Communication establishment” window
“Establish Communication”
window should show
controllers or drivers
connected to COM No.
Selected in (4).
Controllers subject to
the communication
are available to
select.
(3)
Click