IAI XSEL - Page 459

437
Appendix
Appendix
I/O Parameters
No. Parameter name
Default value
(Reference)
Input
range
Unit Remarks
401
to
404
(For expansion) 0
405
to
406
(For expansion) 512
407 (For expansion) 1000
408 (For expansion) 4000
409 (For expansion) 1
410 (For expansion) 0
411 (For expansion) 1256
412 (For expansion) 4256
413
to
414
(For expansion) 0
415
to
416
(For expansion) -1
417
to
419
(For expansion) 0
420 (For expansion) 0H
421 (For expansion) 1003000H
422 (For expansion) FF007530H
423 (For expansion) 2H
424
to
429
(For expansion) 0H
430 (For expansion) 4000
432
to
500
(For expansion) 0
501 Number of RC-gateway
position data points
128 0 to 512 Number of position data used in the RC position data mode
within the XSEL.
(Main application version 0.65 or later/F-ROM 32-Mbit version
only)
502 Maximum axis number
for definition of RC-
gateway position data
0 0 to 15 Maximum axis number used for reserving RC-axis position data
areas in the user-data backup memory
(Main application version 0.65 or later/F-ROM 32-Mbit version
only)
503 Number of position data
points for definition of
RC-gateway position
data
0 0 to 512 Number of position data points used for reserving RC-axis
position data areas in the user-data backup memory
* If 0, no areas are reserved.
* If a value other than 0 is set, areas will be reserved regardless
of whether the RC gateway function is enabled or disabled.
(Main application version 0.65 or later/F-ROM 32-Mbit version
only)
504 Port number of first
shared output port
occupied in RC-gateway
PLC through mode
1000 1000 to
3999
1000 + (multiple of 16)
(Main application version 0.65 or later/F-ROM 32-Mbit version
only)
505 Port number of first
shared output port
occupied in RC-gateway
PLC through mode
4000 4000 to
6999
4000 + (multiple of 16)
(Main application version 0.65 or later/F-ROM 32-Mbit version
only)
506 Communication timeout
period for PC software
connection for RC
gateway RC
3000 0 to 99999 Set a timeout period that applies when connecting to the PC
software for RC.
(Main application version 0.65 or later/F-ROM 32-Mbit version
only)
507
to
510
(For expansion) 0
511 Input port number for
forced release of RC
axis 0 brake
0 0 to 3999 When the applicable port turns ON, the brake will be released
forcibly. (Beware of dropping axis.)
* Invalid, if 0. (Specification of input port No. 0 is invalid.)
(Main application version 0.65 or later/F-ROM 32-Mbit version
only)
Appendix