531
Appendix
Appendix
INTELLIGENT ACTUATOR
(In the panel window, the three digits after “E” indicate an error number.)
.cte,noitca,noitpircseDemanrorrE.oNrorrE
A85 FROM write request error before erase is complete When updating, a flash-ROM write command was received before a
flash-ROM erase command. Confirm that the update program file is
valid and then perform update again.
A86 Absolute-encoder backup battery voltage-low warning (Driver
detection)
The voltage of the absolute-data backup battery is low. Check the
battery connection or replace the battery.
A87 Motorola S-byte count error (Core detection) The update program file is invalid. Check the file.
A88 Message conversion error (Core detection) The received message does not conform to the message format or
contains invalid data. Check the message sent from the host
communication device.
A89 Updating target non-specification error (Core detection) During update, an update command was received before the updating
target was specified properly. Check if an appropriate updating PC tool
is used and the target specification and other settings in the updating
PC tool are correct.
A8A Updating system code error (Core detection) The system code in the message received with the updating target
specification command does not match the controller system. Check the
target specification and other settings in the updating PC tool.
A8B Updating unit code error (Core detection) The unit code in the message received with the updating target
specification command does not match any updatable unit in the
controller. Check the target specification and other settings in the
updating PC tool.
A8C Updating device number error (Core detection) The specified device number in the message received with the updating
target specification command is not appropriate. Check the target
specification and other settings in the updating PC tool.
A8D Flash busy reset timeout (Core detection) Error erasing/writing the flash ROM
CD0 Drive error (Driver detection) Error notification from the driver
CD1 Encoder error (Driver detection) Error notification from the driver
CD2 Driver CPU error (Driver detection) Error notification from the driver
CD3 Servo control error (Driver detection) Error notification from the driver
CD4 Command error (Driver detection) Error notification from the driver
CD5 Motor temperature error (Driver detection) Error notification from the driver
* If “XSEL only” or “SCARA only” is not specified in the “Description, action, etc.” field, basically the error is common to both specifications.
Appendix
To Next Page
Loading...
Need help?
General
