Reference
Code
Description/Action
(Perform all actions before exchanging Failing
Items)
Failing Item
8426 No processor VPD. Record function code 19 from
the operator panel. This function code is the CCIN
identifier which is used to determine the processor
or memory card type. To get the part number for
the failing card, find the CCIN number in the parts
tables under “Electronic Cards” on page 556.
1. Clock/processor regulator card, M19
Location: U1.1-P1-X2
2. Processor card 3, M16
Location: U1.1-P1-C4
9012 Address not valid.
Firmware command had a frame address that was
not valid.
Exchange the SPCN frame-to-frame cables to the
failing frame.
1. Go to “MAP 1520: Power” on page 88,
assume that you do not have an error code
when following the MAP.
2. ac box
Location: U1.2-V7
9013 Invalid node address.
The address in the SPCN command does not
match the secondary nodes assigned address.
Exchange the failing items for the SPCN node
reporting the error.
1. Go to “MAP 1520: Power” on page 88,
assume that you do not have an error code
when following the MAP.
2. SPCN card assembly, R21
Location: U1.1-P2-X1
9014 A command has an invalid address mode.
A command from the system unit specified a unit
address of D or E or had a frame address of 00.
Exchange the failing items in the system unit.
1. SPCN code problem.
2. Go to “MAP 1520: Power” on page 88,
assume that you do not have an error code
when following the MAP.
9021 A command to an SPCN node was rejected.
No action required. This reference code is logged
for information only.
9022 Addressed unit not in frame.
The addressed unit does not exist in the
addressed frame.
No action required. This reference code is logged
for information only.
9023 Addressed unit exists, but the frame is powered
off.
The addressed unit is in a frame that is powered
off.
No action required. This reference code is logged
for information only.
1xxx
Chapter 5. Error Code to FRU Index 205
To Next Page
Loading...
