Table 12. NIS configuration information (continued)
Field Value Note
Use Id Map
[ ] Use ID Map - NIS is used to map
UNIX IDs to Windows IDs for an
environment where Active Directory
(AD) or Samba Primary Domain
Controller (PDC) is used for
Authentication.
If the NIS Mode is Basic, leave this field blank.
If you checked NIS - NFS NetGroup support
without User ID Mapping in the Options field
of Table 9 on page 22, leave this field blank.
If you checked NIS - NFS NetGroup support
with User ID Mapping in the Options field of
Table 9 on page 22, then check the Use ID Map
field.
ID MAP USER
RANGE
If the Use ID Map field is blank, leave this field
blank.
If the Use ID Map field is checked AND at least
one User Map rule is AUTO then you must
specify a User Range and/or a Group Range.
Example: 10000-20000.
Note: The User Range values must be a
minimum of 1024.
ID MAP GROUP
RANGE
If the Use ID Map field is blank, leave this field
blank.
If the Use ID Map field is checked AND at least
one User Map rule is AUTO then you must
specify a User Range and/or a Group Range.
Example: 30000-40000.
Note: The Group Range values must be a
minimum of 1024.
Chapter 1. Before you begin the installation 27
To Next Page
Loading...
