Table 6. IMM error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, “Parts listing, System x3550 M3 Types 4254 and 7944,” on page 159 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Security: Userid: '%1' had %2 login
failures from WEB client at IP address
%3.
(%1 = user ID; %2 =
MaximumSuccessiveLoginFailures
(currently set to 5 in the firmware); %3 =
IP address, xxx.xxx.xxx.xxx)
Error A user has exceeded the
maximum number of
unsuccessful login
attempts from a Web
browser and has been
prevented from logging in
for the lockout period.
1. Make sure that the
correct login ID and
password are being
used.
2. Have the system
administrator reset the
login ID or password.
Security: Login ID: '%1' had %2 login
failures from CLI at %3.
(%1 = user ID; %2 =
MaximumSuccessiveLoginFailures
(currently set to 5 in the firmware); %3 =
IP address, xxx.xxx.xxx.xxx)
Error A user has exceeded the
maximum number of
unsuccessful login
attempts from the
command-line interface
and has been prevented
from logging in for the
lockout period.
1. Make sure that the
correct login ID and
password are being
used.
2. Have the system
administrator reset the
login ID or password.
Remote access attempt failed. Invalid
userid or password received. Userid is
'%1' from WEB browser at IP address
%2.
(%1 = user ID; %2 = IP address,
xxx.xxx.xxx.xxx)
Error A user has attempted to
log in from a Web browser
by using an invalid login ID
or password.
1. Make sure that the
correct login ID and
password are being
used.
2. Have the system
administrator reset the
login ID or password.
Remote access attempt failed. Invalid
userid or password received. Userid is
'%1' from TELNET client at IP address
%2.
(%1 = user ID; %2 = IP address,
xxx.xxx.xxx.xxx)
Error A user has attempted to
log in from a Telnet
session by using an invalid
login ID or password.
1. Make sure that the
correct login ID and
password are being
used.
2. Have the system
administrator reset the
login ID or password.
The Chassis Event Log (CEL) on
system %1 cleared by user %2.
(%1 =
CIM_ComputerSystem.ElementName;
%2 = user ID)
Info A user has cleared the
IMM event log.
No action; information only.
IMM reset was initiated by user %1.
(%1 = user ID)
Info A user has initiated a reset
of the IMM.
No action; information only.
76 IBM System x3550 M3 Types 4254 and 7944: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General
