IBM System x3550 M3 Type 4254 Problem Determination And Service Guide

Table 6. IMM error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, “Parts listing, System x3550 M3 Types 4254 and 7944,” on page 159 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
IP address of network interface modified
from %1 to %2 by user %3.
(%1 =
CIM_IPProtocolEndpoint.IPv4Address;
%2 =
CIM_StaticIPAssignmentSettingData.
IPAddress; %3 = user ID)
Info A user has modified the IP
address of the IMM.
No action; information only.
IP subnet mask of network interface
modified from %1 to %2 by user %3s.
(%1 =
CIM_IPProtocolEndpoint.SubnetMask;
%2 =
CIM_StaticIPAssignmentSettingData.
SubnetMask; %3 = user ID)
Info A user has modified the IP
subnet mask of the IMM.
No action; information only.
IP address of default gateway modified
from %1 to %2 by user %3s.
(%1 = CIM_IPProtocolEndpoint.
GatewayIPv4Address; %2 =
CIM_StaticIPAssignmentSettingData.
DefaultGatewayAddress;
%3 = user ID)
Info A user has modified the
default gateway IP address
of the IMM.
No action; information only.
OS Watchdog response %1 by %2.
(%1 = Enabled or Disabled; %2 = user
ID)
Info A user has enabled or
disabled an OS Watchdog.
No action; information only.
DHCP[%1] failure, no IP address
assigned.
(%1 = IP address, xxx.xxx.xxx.xxx)
Info A DHCP server has failed
to assign an IP address to
the IMM.
1. Make sure that the
network cable is
connected.
2. Make sure that there is
a DHCP server on the
network that can
assign an IP address
to the IMM.
Remote Login Successful. Login ID: %1
from %2 at IP address %3.
(%1 = user ID; %2 =
ValueMap(CIM_ProtocolEndpoint.
ProtocolIFType;
%3 = IP address, xxx.xxx.xxx.xxx)
Info A user has successfully
logged in to the IMM.
No action; information only.
Attempting to %1 server %2 by user
%3.
(%1 = Power Up, Power Down, Power
Cycle, or Reset; %2 =
IBM_ComputerSystem.ElementName;
%3 = user ID)
Info A user has used the IMM
to perform a power
function on the server.
No action; information only.
Chapter 3. Diagnostics 75

IBM System x3550 M3 Type 4254 Specifications

General

Processor	Intel Xeon 5600 series
Max Processors	2
Memory	Up to 192 GB DDR3
Form Factor	1U Rack
Chipset	Intel 5520
Drive Bays	Up to 4 hot-swap 2.5-inch SAS/SATA or SSD
RAID Support	RAID 0, 1, 10
Network Interface	Dual-port Gigabit Ethernet
Power Supply	460W or 675W
Expansion Slots	2 PCIe 2.0
Weight	Approximately 17.24 kg (38 lbs)
Memory Slots	18 (RDIMM) or 12 (UDIMM)