Rev AA Installing the Ribbon in the Cassette 3-11
8 Slide the empty spool completely down onto the holder that has a
silver disc (Figure 3-10).
9 Turn the empty spool by hand to take up any excess ribbon. Stop
turning the empty spool when the full spool starts to rotate (Figure 3-
11).
Note: If the supplied ribbon has a transparent section or printed leader at the
start, rotate the empty spool to take up all the transparent ribbon.
10 Insert the cassette into the printer body.
Figure 3-10: Ribbon Spool Complete
Figure 3-11: Ribbon Spool Routing
ICE Pegasus Service Manual
To Next Page
Loading...