Rev AA 6-1
6
System Events
This chapter contains the following topic:
• List of faults and warnings
Table 6-1 lists the faults and warnings
Error
No
Report on CLARiTY Operator Interface Status
E1001 ‘Count Limit Reached’ - One or more of the counters
in the image has reached the end value set in the
image design. Please select a new job and touch the
Clear button to restart the printer.
Fault
E1002 ‘Operation Aborted’ - The operation of the printer has
been intentionally aborted by a host control system.
When ready to resume the operation, the host control
system cleared this abort condition, and then this fault
message clear automatically.
Fault
E1003 ‘Real-time Clock Fault’ - There is a problem with the
real-time clock which is required for the system to
operate correctly.
Fault
E1004 ‘Backup Battery is Flat’ - The battery which powers
the printer's clock is flat. This means that the date and
time, the currently selected job and some
performance data is lost when the printer is switched
off.
Warning
E1006 ‘Image Update Failure’ - CLARiTY is unable to update
the image that is printed next. This usually occurs
because products are too close to each other. Touch
the Clear button to restart the printer.
Fault
E1007 ‘Image Update Failure’ - CLARiTY is unable to update
the image that is printed next. This usually occurs
because products are too close to each other. Touch
the Clear button to restart the printer.
Fault
E3000 ‘Printer Hand Not Set’ - Set the Printer hand in CLAR-
iTY Config
Fault
Table 6-1: List of Faults and Warnings
To Next Page
Loading...
Need help?
General
