Switching on for the first time
First insert batteries provided into the remote control. Take care when opening the
battery compartment and insert the batteries observing the polarity, which is
marked on the base of the battery compartment.
Ensure that your television set is switched on and on the correct video channel so
that you will be able to see the on-screen display from the digital receiver.
Once you have checked that you have connected your digital receiver correctly,
you can then plug in the mains power.
Press the button on the top left corner on the remote control. In a few
moments, you should see an on-screen menu and you should see the channel
indicator lit on the front panel of the receiver.
If you do not see anything on your TV, try pressing the V Format button on the
remote control. If after several tries you still get no picture, check that the television
is set to the correct input.
When you see the on-screen menu, you can start searching for available television
and radio services.
CAUTION
If the digital receiver no longer responds properly to the remote control
commands, first check that the IR sensor is not obstructed. Otherwise the
batteries in the remote may be flat. Replace only with 1.5 V AAA size batteries.
Do not mix different types of batteries, or new with old batteries.
Do not use rechargeable batteries.
Never recharge the old batteries.
Observe the polarities indicated inside the battery compartment.
Replace exhausted batteries immediately.
If you are not using the remote control for a long period of time, remove the
batteries. The manufacturer accepts no liability for the damage resulting
from leaking batteries.
Please dispose of used batteries in an environmentally sound manner.
Quick Start Guide
To Next Page
Loading...