Unpacking
Please check that you have received the following items with the digital receiver.
Remote control unit
Two batteries for the remote control(AAA 1.5V)
One HDMI cable
A copy of this User Manual
Note: Accessories may vary according to your local area.
Safety precautions
Please read carefully the following safety precautions.
This unit is designed to operate between 90 and 250 volts. Please consult your local
installer if you are unsure of your local mains supply voltage before installation.
The mains adapter should be readily accessible so it can be easily unplugged when
necessary.
Note: This digital receiver is designed for indoor use only.
Expose the digital receiver to any liquids or install the unit in high humidity locations
such as bathrooms etc.
Remember to provide adequate ventilation w
allowing a minimum of 10cm of space surrounding the unit. Avoid placing the unit on
top of another device such as DVD player etc.
hen installing the unit in a cabinet, by
Place the digital receiver on a firm and level surface.
Place the digital receiver close to any heat sources or in direct sunlight.
Cover the unit as it will impair the cooling of the unit.
Protect the power cord from being damanged. If the cord is damaged, do not use the
digital receiver and get the cord replaced by a qualified service technician.
Open the digital receiver casing under any circumstances, or the warranty will be
void. Refer all repairs to a qualified service technician.
Do Not:
Connect or disconnecting anything to the unit whilst the unit is powered, apart from
USB accessories.
Do:
Disconnect the unit from mains power supply when the unit is to be left unused for
long periods of time.
Disconnect the unit from mains power and from the aerial when a thunderstorm is
expected.
Use any solvents or spray cleaner to clean the unit..
Use only a lightly damp cloth to clean the unit.
Quick Start Guide
To Next Page
Loading...