Memory scan searches through memory channel 1 to
99 for signals. Blank (unprogrammed) memory chan-
nels are skipped.
➀ Push [V/M] to select memory mode, if necessary.
➁ Push [MENU] to select M2.
➂ Push [F1] to select the scan menu.
➃ Push [F1] to start/stop memory scan.
• The MHz and kHz decimal points flash during scan.
• At least 2 memory channels must be programmed for
memory scan to proceed.
• Rotating the tuning dial during memory scan cancels the
scan.
Select memory scan searches through memory chan-
nel set as “select” for signals. See below for
setting/deleting select memory channels
➀ Follow the steps above to start memory scan.
➁ During memory scan, push [F3] to toggle between
memory scan and select memory scan.
➂ Push [F1] to stop the scan.
• At least 2 memory channels must be programmed for
memory scan to proceed.
• Rotating the tuning dial during memory scan cancels the
scan.
■ SETTING/DELETING SELECT MEMORY
CHANNELS
All memory channels except scan edges (P1, P2) can
be set as select memory channels.
While the scan menu is selected, push [F3] to toggle
a memory channels select setting.
•“SEL” appears when a channel is set as a select channel.
To Next Page
