Icom IC-9100 - Page 187

178
17
MAINTENANCE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
D3CANNING
02/",%- 0/33)",%#!53% SOLUTION REF.
Programmed scan does not
stop.
s3QUELCHISOPEN s3ET THE ;2&31,= CONTROL TO THE THRESHOLD
point.
pp. 44,
146
Programmed scan does not
start.
s
The same frequencies have been programmed
into both “1A–3A” and “1b–3b” of the scan edge
memory channels.
s0ROGRAMDIFFERENTFREQUENCIESINTOTHE“1A–3A”
and “1b–3b” scan edge memory channels.
p. 148
Memory scan does not start. s OR MORE MEMORY CHANNELS HAVE NOT BEEN
programmed.
s0ROGRAMMORETHANMEMORYCHANNELS p. 140
Select memory scan does
not start.
s OR MORE MEMORY CHANNELS HAVE NOT BEEN
designated as select channels.
s$ESIGNATE MORE THAN  MEMORY CHANNELS AS
select channels for the scan.
p. 151
Mode select memory scan
does not start.
sORMOREMEMORYCHANNELSWITHDESIREDMODE
have not been programmed.
s0ROGRAM MORE THAN  MEMORY CHANNELS WITH
the desired operating mode.
p. 43
∂F scan does not start. s4HE CENTER FREQUENCY FOR∂F scan is not pro-
grammed.
s0ROGRAMTHECENTERFREQUENCYFORA∂F scan. p. 152
D$ISPLAY
02/",%- 0/33)",%#!53% SOLUTION REF.
The displayed frequency
does not change properly.
s4HEDIALLOCKFUNCTIONISturned ON.
s4HE3ETMODESCREENISSELECTED
s4HEINTERNAL#05HASMALFUNCTIONED
s(OLD DOWN ;30%%#(,/#+= FOR  SECOND TO
turn OFF the function.
s0USH[MENU] to exit the Set Mode.
s2ESETTHE#05
p. 77
p. 161
p. 181