200
20
OPTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
CT-17 CI-V LEVEL CONVERTER UNIT
For remote transceiver control using a
personal computer equipped with an
23# PORT 9OU CAN CHANGE FRE-
quencies, operating mode, memory
channels, etc., via your computer.
s AG-25
WEATHER-PROOF PREAMPLIFIER (for 144 MHz Band)
s AG-35
WEATHER-PROOF PREAMPLIFIER (for 430 MHz Band)
External all-weather, mast mounting preamplifiers for com-
pensating for coaxial cable loss.
s AG-2400 DOWN CONVERTER UNIT
All-weather, satellite down converter with superior NF and
gain.
Input frequency : 2400–2402 MHz
Output frequency : 144–146 MHz
Conversion gain : More than 25 dB
Total NF : Less than 1.5 dB
s OPC-1529R DATA COMMUNICATION CABLE (RS-232C type)
Allows low-speed data communication in the DV mode, and
receiving a GPS data from a third-party GPS receiver.
s OPC-599 ADAPTER CABLE
13-pin, ACC connector to 7-pin + 8-pin ACC connector.
s-" CARRYING HANDLE
Convenient when carrying the transceiver.
The same as that attached with the transceiver.
s UT-121
DIGITAL UNIT
Allows the DV mode operation with the IC-9100.
s CS-9100 CLONING SOFTWARE
Use this software to program settings, memory channels
and set mode contents quickly and easily via your PC’s
USB port.
A USB cable is required. (A-B type, purchase separately)
s23"! IP REMOTE CONTROL SOFTWARE
To remotely control radios using the RS-BA1, "%352%
that you comply with your local regulations.
Approved Icom optional equipment is designed for
optimal performance when used with an Icom trans-
ceiver.
Icom is not responsible for the destruction or damage
to an Icom transceiver in the event the Icom trans-
ceiver is used with equipment that is not manufac-
tured or approved by Icom.
To Next Page
Loading...
