Icom IC-M91D - Page 53

46
8
DSC OPERATION
N
ew
2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Manual Reply:
Enter “POSITION REPLY” in the DSC CALLS menu. q
❮MENU❯ ➪ ❮DSC Calls❯ ➪ ❮Position Reply❯
(Push [MENU])
(Push [Y]/[Z] , then push [ENTER].)
• If no Position Request call has been received, the “POSITION
REPLY” item will not be displayed.
Select a desired Position Request call to reply to, using w
[Y]/[Z], then push [ENTER].
The Position Reply call confi rmation screen is displayed. e
Push [CALL] to transmit the acknowledgement call.
While transmitting the reply call, the screen shown below r
is displayed, and then returns to the normal operating
mode.
When no GPS data is received or invalid data is received,
and both position and time have been manually programmed,
the screen shown below appears. Edit your latitude and lon-
gitude position and UTC time as follows:
Push [CHG], then edit your latitude and longitude position ➥
and UTC time.
• Select a desired number using [Ω]/[≈].
• Push [ENTER] to set it.
• To move the cursor, select either arrow, “←” or “→,” then push
[ENTER].
• Select N (North latitude) or S (South latitude) when the cursor
is on the ‘N’ or ‘S’ position.
• Select W (West longitude) or E (East longitude) when the cur-
sor is on the ‘W’ or ‘E’ position.