© 2009 IDS Imaging Development Systems GmbH60
User Manual uEye Cameras V3.32
Since the sample program has to open the camera, please make sure the selected
camera is not used by other applications at the same time.
8.1.8 Automatic ETH Configuration
The button allows configuring a connected GigE uEye camera for automatic
IP address assignment. The function defines a suitable IP address range, which you can change in
the Manual ETH configuration dialog box, if required.At the same time, it deletes the camera's
persistent IP address (i.e. sets it to 0.0.0.0). When the GigE uEye camera is opened by an
application, the function automatically assigns a free IP address to the camera.
This function is only available for GigE uEye cameras.
8.1.9 Starter Firmware Upload
The button uploads a new version of the starter firmware to the selected
camera. This button is only available in Expert mode and is hidden otherwise.
The starter firmware determines the start-up behavior of the GigE uEye camera. We
recommend that you do not update the starter firmware unless an older firmware version
causes start-up problems. If you have questions on the current starter firmware, please
contact our technical support (see Contacting Us).
This function is only available for GigE uEye cameras.
8.1.10 Manual ETH Configuration
This dialog box allows you to manually set the IP address and subnet mask of a GigE uEye camera.
The button is only available in Expert mode and is hidden otherwise.
This function is only available for GigE uEye cameras.
To Next Page
Loading...
Need help?
General