ROCKY-4786EV/EVG User Manual
Page 98
If the ECP mode is selected in the Parallel Port Mode configuration option, you will be
able to configure the ECP Mode Use DMA option. This option determines the DMA
channel the parallel port uses when it is in the ECP mode.
1 Parallel port uses DMA Channel 1 in the ECP mode
3 (DEFAULT) Parallel port uses DMA Channel 3 in the ECP mode
PWRON After PWR-Fail [Off]
This PWRON After PWR-Fail option allows you to select the state the system will return
to if there is a power failure or power to the system is suddenly cut off.
Off
(D
EFAULT) After the power returns the system will remain off.
On
After the power returns, the system will turn on
Former-Sts
After the power returns the system will return to its
original state. If it was off, it will remain off. If it was on,
it will turn on again.
Watch Dog Timer Unit [Second]
The Watch Dog Timer Unit default is set to second and is non-configurable.
5.6 Power Management Setup
The Power Management Setup menu (BIOS Menu 12) allows you to set the power
management and saving features in the BIOS.
To Next Page
Loading...
Need help?
General
