ROCKY-4786EV/EVG User Manual
Page 71
Selecting IDE HDD Auto-Detection option and pressing the “ENTER” key will enable the
BIOS to automatically detect the HDD type. Do not set this option manually.
IDE Channel 0/1 Master/Slave [Auto]
The IDE Channel option allows you to activate or deactivate the following drive channels:
Channel 0 Master
Channel 0 Slave
Channel 1 Master
Channel 0 Slave
None
If no drives are connected to the IDE channel select this
option. Once set, this IDE channel will become
inaccessible and any drives attached to it undetected.
Auto
(D
EFAULT) Setting this option allows the device to be automatically
detected by the BIOS
Manual
Selecting this option allows you to manually configure
the device on the IDE channel in BIOS.
Access Mode [Auto]
The Access Mode option allows you to determine the hard disk BIOS translation modes.
Most systems now use hard drives with large capacities and therefore either the LBA
translation mode or auto mode should be selected.
CHS
Select this mode if the HDD capacity is less than
504MB.
LBA
Select this mode if the HDD capacity is more than
8.4GB.
Large
This mode is an extended ECHS mode and while it
supports HDDs larger than 504MB, it is not
recommended.
Auto
(D
EFAULT) If you are unsure of what access mode to set, select this
option
To Next Page
Loading...
Need help?
General
