ROCKY-4786EV/EVG User Manual
Page 52
4.3.3.2 DIMM Module Installation
The ROCKY-4786EV/EVG CPU Board has two DDR SDRAM DIMM sockets. To install the
DIMM modules, follow the instructions below.
Step 4: Pull the two white handles on either side of the DIMM socket down.
Step 5: Align the DIMM module with the DIMM socket making sure the matching pins
are correctly aligned.
Step 6: Insert the DIMM module slowly. Once you are sure it is correctly inserted, push
down firmly. The white handles on either side of the socket will move back up
and lock the module into the socket. Step 0:
4.3.4 Backplane Installation
Before the ROCKY-4786EV/EVG can be installed into the chassis, a backplane must first
be installed. Please refer to the installation instructions that came with the backplane and
the chassis to see how to install the backplane into the chassis.
NOTE:
IEI has a wide range of backplanes available. Please contact your
ROCKY-4786EV/EVG vendor, reseller or and IEI sales representative
at
sales@iei.com.tw or visit the IEI website at http://www.ieiworld.com
to find out more about the available chassis.
4.3.5 CPU Card Installation
To install the ROCKY-4786EV/EVG CPU card onto the backplane, carefully align the CPU
card interface connectors with the corresponding socket on the backplane. To do this,
please refer to the reference material that came with the backplane. Next, secure the CPU
card to the chassis. To do this, please refer to the reference material that came with the
chassis.
To Next Page
Loading...
Need help?
General
