ROCKY-4786EV/EVG User Manual
Page 47
WARNING:
The installation instructions described in this manual should be
carefully followed in order to prevent damage to the components and
injury to the user.
Before and during the installation please DO the following:
Read the user manual:
o The user manual provides a complete description of the
ROCKY-4786EV/EVG installation instructions and configuration options.
Wear an electrostatic discharge cuff (ESD):
o Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.
Place the ROCKY-4786EV/EVG on an antistatic pad:
o When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.
Turn all power to the ROCKY-4786EV/EVG off:
o When working with the ROCKY-4786EV/EVG, make sure that it is
disconnected from all power supplies and that no electricity is being fed
into the system.
Before and during the installation of the ROCKY-4786EV/EVG DO NOT:
Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
Use the product before verifying all the cables and power connectors are
properly connected.
Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
To Next Page
Loading...
Need help?
General
