EasyManua.ls Logo

IGBT CO2 - Safety Precautions and Usage Guidelines; Safe Definition

IGBT CO2
86 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety Precautions
Safe Definition
Danger
Follow instructions to perform operations. Failing to do so may result in death or serious
injuries.
Note
!
Follow instructions to perform operations. Failing to do so may result in medium or slight
injuries or property damages.
Read this document before using the welder to ensure proper use.
Although this welder is designed and manufactured with safety considerations, pay attention to
the precautions specified in this document when using the welder, so as to ensure the safety of
you and related personnel and prevent serious accidents.
Misuse of this welder may cause injuries.
Safety Precautions
Danger
Before moving the welder, cut off the input power of the distribution box.
When using a crane to move the welder, make sure that the hoist ring has been tightened and
the housing and cover plates of the welder have been installed.
If a crane is required to move the welder, use two lifting belts and the included angle of each
lifting belt and the vertical direction must be less than 15 degrees.
Do not lift the welder and other objects at the same time.
Install the welder on non-inflammable objects to prevent fire risks.
Do not place inflammable objects near the welder; failing to do so may result in fires.
Do not install the welder in an environment with explosive gas; failing to do so may result in
explosion risks.
Cabling must be performed by certified personnel; failing to do so may result in electric shock.
Before cabling, make sure that the power input has been disconnected completely; failing to do
so may result in electric shock.
Before connecting the power supply, connect the grounding terminal of the welder properly;
failing to do so may result in electric shock.
Before connecting the power supply, install the cover plate; failing to do so may result in electric
shock.
Do not touch terminals when the power supply is connected; failing to do so may result in electric
shock.
Do not operate the welder with wet hands; failing to do so may result in electric shock.

Table of Contents

Related product manuals