62 Chapter 3 Welder Operation Description
Ehave Series Full Digital IGBT CO
2
/MAG/MMA Multifunctional Inverter Welder User Manual
3.7 Restoring Factory Settings
Press the SAVE and LOAD buttons at the same time. The middle screen displays
F01. Press the ENTER button. The factory settings are restored. See Figure 3-49.
SAVE
Feed
wire
Job No.
ON
Over-
temperature
Manual
MAG
LOAD
ENTER
Ending
arc
current
Spot
welding
time
Ending
arc
voltage
Arc
dynamic
Detect
gas
Synergic
CO2
Solid wire
Flux-cored
wire
Electrode
Spot welding
Welding without
ending arc
Welding with
ending arc
Repeated
welding with
ending arc
Gas type
Output
control
Wire
type
Wire
diameter
Welding
control
Figure 3-49 Restoring the factory settings
Note
1. When the factory settings of the welder are restored, the parameters saved to channels are not
deleted.
2. When the factory settings of the welder are restored, the lock password is not deleted.
To Next Page
Loading...
