44 Chapter 3 Welder Operation Description
Ehave Series Full Digital IGBT CO
2
/MAG/MMA Multifunctional Inverter Welder User Manual
3.4.9 Wire Inching
Method 1: Use the Wire Inching button on the control panel of the welder to inch wire.
The procedure is as follows:
1. Hold down the Wire Inching button on the control panel to enable the wire feeder to
inch wire directly.
2. Release the Wire Inching button and wire inching stops.
3. Figure 3-19 shows the control panel where the parameters have been set.
SAVE
Feed
wire
Job No.
ON
Over-
temperature
Manual
MAG
LOAD
ENTER
Ending
arc
current
Spot
welding
time
Ending
arc
voltage
Arc
dynamic
Detect
gas
Synergic
CO2
Solid wire
Flux-cored
wire
Electrode
Spot welding
Welding without
ending arc
Welding with
ending arc
Repeated
welding with
ending arc
Gas type
Output
control
Wire
type
Wire
diameter
Welding
control
Figure 3-19 Setting wire inching
Method 2: Use the Wire Inching button on the remote control box of the wire feeder (see
Figure 3-20) to inch wire. The procedure is as follows:
1. Hold down the Wire Inching button on the remote control box of the wire feeder to
enable the wire feeder to inch wire directly.
2. Release the Wire Inching button and wire inching stops.
To Next Page
Loading...
