IGBT CO2 - Page 40

32 Chapter 3 Welder Operation Description
Ehave Series Full Digital IGBT CO
2
/MAG/MMA Multifunctional Inverter Welder User Manual
SN
Name
Function
1
SAVE
1. Saves selected welding parameters.2. Sets a password when the locking
function is used.
2
LOAD
1. Loads saved welding parameters.2. Implements password-based locking.
3
ENTER
1. Confirms loading of and saves welding parameter settings.2. Implements
common control panel locking.
4
Inch wire
Quickly inches wire without gas flow, reducing gas usage.
5
Ending arc
current
Adjusts the ending arc current in the mode of welding with ending arc and the
mode of welding with repeated ending arc.
6
Spot welding
time
Sets the time for spot welding.
7
Ending arc
voltage
Adjusts the ending arc voltage in the mode of welding with ending arc and the
mode of welding with repeated ending arc.
8
Arc dynamic
Sets the hardness of arc.
9
Detect gas
Detects gas flow.
12
Gas type
Selects the type of the shielding gas. MAG indicates the mixed gas consisting of
80% Ar and 20% CO
2
.
11
Output control
Manual
indicates that the current and voltage can be set independently.
Synergic
indicates that the voltage varies with the current and the voltage can
only be 9 V more or less than the system-defined value. In synergic mode, rotate
the voltage adjusting knob on the control panel of the wire feeder to select the
standard range.
12
Wire type
Selects the type of the welding wire. If
Gas type
is set to
MAG
, the system
disables the
Flux-cored wire
option. If
Wire type
is set to
Electrode
, the
system enters the manual arc welding mode.
13
Wire diameter
Selects the diameter of the welding wire. If
Wire type
is set to
Flux-cored wire
,
the system allows only the wire diameters 1.2 mm and 1.6 mm.
14
Welding control
Selects the welding control mode.