46 Chapter 3 Welder Operation Description
Ehave Series Full Digital IGBT CO
2
/MAG/MMA Multifunctional Inverter Welder User Manual
SAVE
Feed
wire
Job No.
ON
Over-
temperature
Manual
MAG
LOAD
ENTER
Ending
arc
current
Spot
welding
time
Ending
arc
voltage
Arc
dynamic
Detect
gas
Synergic
CO2
Solid wire
Flux-cored
wire
Electrode
Spot welding
Welding without
ending arc
Welding with
ending arc
Repeated
welding with
ending arc
Gas type
Output
control
Wire
type
Wire
diameter
Welding
control
Figure 3-21 Saving parameter settings
The procedure for method 2 is as follows:
1. Select the parameter settings to be saved.
2. Press the SAVE button. The Job No. indicator turns on and the SAVE
indicator flashes.
3. Use the knob to select a channel number (0 - 9). See Figure 3-21.
4. Press the ENTER button to save the parameter settings. After the parameter
settings are saved, the indicators turn off.
Note:
If you want to abort the saving operation during the procedure, press the SAVE button
again.
Note
1. If you set Wire type during the procedure, Electrode cannot be selected.
2. When a channel is selected for data storage, the original data of the channel is overwritten.
3. When the factory settings of the welder are restored, the saved parameter settings are not
deleted.
LOAD
The procedure is as follows:
1. Press the LOAD button. The Job No. indicator turns on and the LOAD
indicator flashes.
To Next Page
Loading...
