34 Image Vault
®
PRO Command
3 Software on Your PC
The software package you install on your PC is called “PRO-Command Playback.”
This application allows you to connect your PC to a DVR by network or modem.
The remote software is identical in most respects to the Playback Mode software
running on the DVR (See Section 2.3). In addition to remotely viewing video and
being able to perform all the same setup, Playback allows you to review video
copied from the DVR via CD/DVD, USB, or remote download.
3.1 Installing PRO-Command Playback
The CD included with this manual contains the full installation of the PRO-Com-
mand Playback software package. Install PRO-Command Playback on your PC
to connect to your DVR(s). Connection options include modem and TCP/IP (via
Ethernet NIC). To complete installation* follow these simple steps:
1. Insert CD into your PC.
2. If the Autoplay feature is disabled on your PC, perform these additional
steps:
a. Select RUN from the START menu.
b. Type “d:\setup.exe” (substitute drive designation if your CD drive is
something other than the D drive).
c. Click OK.
3. At the main menu select “Install Playback Software.
4. Follow the directions provided.
If you already have an earlier version of playback on your PC, you do not need to
uninstall it. The older version will be needed to connect to existing Image Vault
DVRsyouhaveintheeldrunningrecordingsoftwareolderthanVersion9.0.
After completing installation the initial main menu will still be on the screen. From
here you may choose to open this manual electronically or take advantage of any
of the other extras found on the CD.
To Next Page
Loading...