Image Vault PRO COMMAND - 8 System Setup; 8.1 TCP;IP Settings

65 Image Vault
®
PRO Command
8 System Setup
System setup involves those features which involve DVR operation but do not
directly involve video, audio or data processes. Each feature is explained in a
generalsense.Fordetailedexplanationsofspecicfeaturespleaserefertothe
help menu built into your software. Service level permission is required in order
toaccessandconguremostoftheitemsdescribedbelow.
8.1 TCP/IP Settings
Consultyournetworkadministratorbeforeconguringanynetworksettingsand
in particular before actually connecting your DVR to a network. Refer to Part I
Section 3.13 for additional information about connecting remotely. To access
TCP/IP settings select “TCP/IP Setup” from the Edit Params submenu of the Status
menu.
IP Address
Enable Obtain IP Address Automatically only if your DVR is connected to a net-
work with Dynamic Host Control Protocol (DHCP) service administrated by an NT
Server on a network. Otherwise enter the IP Address, Subnet Mask, and Gateway
(if applicable) provided by your network administrator. You may need to enter
information into the secondary network interface if equipped. The default IP Ad-
dress is 192.168.0.1 and the default Subnet Mask is 255.255.255.0. Add DNS ad-
dressesonlyifspeciedbyyournetworkadministrator.IfaDHCPserviceisused,