Image Vault PRO COMMAND - A.8 Power Loss; APPENDIX B: FACTORY DEFAULTS; Factory Defaults List

72 Image Vault
®
PRO Command
A.8 Power Loss
These are general steps. No matter how obvious they may seem, check each one.
• Checkyourproductisswitchedon.
• CheckthatyourUPSisswitchedon.
• Checkthatpowercordsarermlyconnectedatbothends.
• VerifytheACoutlethaspower.
• Checkthatyouarenotconnectedtoaswitchedpoweroutlet.
• Checkyourcircuitbreaker.
• IfyoucanverifythatyouhavepowertotheDVR,presstheResetbut-
ton on your DVR.
• ContactImageVaultTechnicalServiceifyouareunabletondthe
problem.
APPENDIX B: FACTORY DEFAULTS
The following items* may be edited from these defaults:
Auto-Detect All Cameras ...........................................................................................................OFF
Motion Detection (all available cameras) .............................................................................ON
Image Capture Rate ..........................................................................1 Image/Camera/Second
Quality Factor .................................................................................................................3 (Medium)
Image Resolution ..............................................................................................................320 x 240
Camera Titles ...................................................................................“Camera 1” to “Camera 16”
Daylight Savings Time ..................................................................................................................ON
NTSC Output Switch Rate ............................................................................................. 4 Seconds
NTSC Camera Display ..........................................................................................................ALL ON
VGA Camera Display ............................................................................................................ALL ON
Motion Display Grids ....................................................................................................................ON
Time Zone .........................................................................................................................PacicUSA
Location Titles .............................................................................................................................Blank
IP Address .........................................................................................................................192.168.0.1
Subnet Mask ....................................................................................................................255.255.0.0
Scheduled Recording ..................................................................................................................OFF
Record During Remote Connection ......................................................................................OFF
Audio Recording ...........................................................................................................................OFF
External Inputs................................................................................................................................OFF
Data Stream ....................................................................................................................................OFF
Idle Time to Hang Up ...................................................................................................10 Minutes
Continuous Timeout .....................................................................................................10 Minutes
*This is not an exhaustive list.
The following parameters may not be edited:
Rings to Auto-Answer