Imagine Platinum VX - HDMI Converters

Platinum™ VX
Installation and Operation Manual Platinum VX Specifications and Power
© 2016 Imagine Communications Corp. Proprietary and Confidential. Version 1.2 | Page 76
Item
Specification
Propagation delay
 NTSC: 260 us
 PAL: 231 us
Power Consumption
Typical: 1020 mW
SFP+2E+ENC Dual Electrical Transmitters Specifications
The SFP+2E+ENC is a dual electrical transmitter SFP module that encodes video composite (CVBS) signals
over 75 ohm coaxial cables via HD-BNC connectors. The module converts SD-SDI signals to NTSC/PAL
composite output.
Table 25: SFP+2E+ENC Dual Electrical Transmitter Specifications
Item
Specification
Connector Type
HD-BNC
Standards
NTSC, PAL-M, PAL-B/G/H/I/D, PAL-N
Impedance
75 ohms
Return Loss
30 dB (typical) from 0.1 MHz to 6 MHz
Output level
0 - 1.0 V pk-to-pk (300 mV DC offset)
Resolution
0 bits
Luminance Nonlinearity
Typical: ±0.5%
Differential Gain
Typical: 0.5% (NTSC)
Differential Phase
Typical: 0.6 deg (NTSC)
Signal-to-Noise Ratio
58 dB, typical, luma ramp
Propagation delay
 NTSC: 3.4 us
 PAL: 3.2 us
Power Consumption
Typical: 1220 mW
HDMI Converters
SFP+HDMI+OUT Specifications
The SFP+HDMI+OUT is an electrical transmitter module designed to convert SDI signals to an HDMI
output without scaling artifacts. Up to eight channels of audio are supported in HDMI mode.
Table 26: SFP+HDMI+OUT Specifications
Item
Specification
Connector Type
HDMI 1.4 type-D