IMS ROBOTICS MICRO S - Page 12

MICRO S automatic Cutter motor
Number:
RH-11.014 A
Scope:
IMS Robotics
Document Management
Date:
08 July 2022
Author:
00145
Checked:
Page:
12 of 113
1. Clamp the rotor in a vice or something similar
2. Using a plastic hammer, remove the rotor out
of the large ball bearing.
3. Replace the ball bearing and/or venting ring if
necessary.
1. Remove the circlip (on the side opposite to the
rotor)
2. Remove the rotor using a mandrel/pin punch
(identical to the large ball bearing)
1. Mount the shim and small ball bearing onto
the rotor.
Caution
Pay attention to the shim beneath the
small ball bearing!