IMS ROBOTICS MICRO S

To Next Page

To Previous Page

MICRO S automatic Cutter motor

Number:

RH-11.014 A

Scope:

IMS Robotics

Document Management

Date:

08 July 2022

Author:

00145

Checked:

Page:

5 of 113

27. Hazard labelling ............................................................................................................................................................. 1

28. Revision history ............................................................................................................................................................. 2

29. Technical changes ......................................................................................................................................................... 3

Main Page

Foreword2
Liability2
Technical Data2
Important Information on Repair3
Table of Contents4
Assembly and Testing Equipment6
Replacing the Air Motor11
Exchange Air Motor Housing16
Removing the Lifting Air Bag19
Mounting the Lifting Air Bag21
Removing the Front Radial Air Bag26
Mounting the Front Radial Air Bag29
Removing the Rear Radial Air Bag32
Mounting the Rear Radial Air Bag38
Removing the Axial Movement Mechanism47
Mounting the Axial Movement Mechanism50
Compress Axial Hose53
Replacing the DN 8 Axial Hose56
Removing the Front Rotary Unit61
Mounting the Front Rotary Unit63
Replacing the Brush Unit in the Rotary Unit67
Removing the Disc Grinding Ring71
Mounting the Disc Grinding Ring72
Motor Unit Assembly75
Soldering the 8-Pole Cable Connector81
Replacing the Spring Contact PCB Camera83
Replacing Sapphire Glass Panes in87
Intermediate Inspection/Leak Detection90
Change Lifting Bladder90
Change Axial Muscle92
Change Radial Bubble93
Final Inspection/Testing of All Functions96
Check Nitrogen System for Leaks96
Error Events and Their Causes97
Check the Compressed Air System for Leaks99
Check Electrical Assemblies101
Problems, Possible Causes, Test Methods and Remedies103

IMS ROBOTICS MICRO S - Page 5

Table of Contents